Yuantao NING+
,
Fei WEN
,
Huaizhi ZHOU
,
Deguo DENG
,
Institute of Precious Metals Kunming
,
650221
,
China
材料科学技术（英）
The influence of 0.1-0.6 at.-%RE additions (RE= La, Ce, Pr, Nd, Sm, Eu, Gd, Tb, Dy, Er, Yb) on the mechanical properties of Pd was studied. All above RE additions increased not only the strength properties at ambient temperature but also the tensile strength, creep rupture time and activation en- ergy at high temperatures, simultaneously increased the elongation of Pd. In the range of dilute con- centration, the strength properties of Pd-RE alloy enhanced linearly with RE concentration. When the strength properties of Pd-RE alloys were normalized at 0.1 at.-%RE, it was found that light RE elements had stronger effect on the properties of Pd than heavy RE, whereas Eu, Yb, Ce had anoma- lous effect. In all Pd-RF alloys, Pd-Eu alloy had the highest strength properties, successively Pd-Yb and Pd-Ce alloy. The effect mechanisms of RE in alloy, such as purifying impurities, increasing recrystallization temperature, refining grain size. expanding crystal lattice, increasing dislocation den- sity and decreasing stacking fault energy, forming stable RE oxidation by internal oxidation, and so on, were observed. They were strengthening sensitive factors. The influence of the factors on strength properties and elongation of Pd was discussed.
关键词:
RE
,
null
,
null
Fei WEN
,
Yuantao NING
,
Huaizhi ZHAO and Deguo DENG(Kunming Institute of Precious Metals
,
Kunming
,
650221
,
China)
材料科学技术（英）
The influence of RE (RE = La, Ce. Pr. Nd, Sm, Eu, Gd. Tb. Dy, Er, Yb) additives with dilute concentrations on the electrical properties of Pd has been studied. All RE elements increase the specific resistivity (ρ) and decrease the resistance temperature coefficient (α) of Pd. and (ρ.α) Pd-RE ls equal to (ρ· α)Pd.The RE elements before Gd reduce the thermo-emf of Pd on Cu. other heavy RE enhance the thermo-emf.The experimental data of normalized Pd-0.1 at.-%RE alloys indicate that the effect of light RE additives on the specific resistivity of Pd is larger than that of heavy RE and Ce. Eu and Yb show anomalous strong effect. The valence and atomic size are main factors influencing the electrical properties.
关键词:
Haihua LIU
金属学报(英文版)
doi:10.1016/S1006-7191(08)60120-9
A novel method was reported to measure the remnant magnetic field in Lorentz mode in a FEI Tecnai F20 transmission electron microscope equipped with a Lorentz lens. The movement of the circle Bloch line of the cross-tie wall in Permalloy is used to measure the remnant magnetic field by tilting the specimen and adjusting the objective lens current. The remnant magnetic field is estimated to be about 17 Oe, in a direction opposite to that of the objective lens magnetic field. The remnant magnetic field can be compensated by adjusting the value of the objective lens current.
关键词:
Lorentz electron microscopy
,
Lorentz lens
,
remnant magnetic field
,
Permalloy
,
cross-tie walls
刘天成
,
卢志超
,
李德仁
,
孙克
,
周少雄
,
卢燕平
功能材料
采用电沉积方法从硫酸盐体系镀液中沉积得到Fe18Ni82合金薄膜.运用扫描电子显微镜(SEM),原子力显微镜(AFM),透射电子显微镜(TEM)和X射线衍射分析(XRD)以及磁测量设备分别对薄膜的表面形貌、显微结构和磁性能进行表征和测量.同时利用万能材料试验机和显微硬度计测量了薄膜的力学性能.结果表明:电沉积制备的Fe18Ni82合金薄膜成分均匀,表面平整、光亮、致密,晶粒大小为40～50 nm.薄膜是以Ni为溶剂原子,Fe为溶质原子的置换型固溶体,只存在单一的fcc相,Fei8Ni82合金薄膜沿(111)面有较强的择优取向.镀态Fei8Ni82合金薄膜在50 Hz交流磁场下,测得其饱和磁感应强度为1.08 T,最低矫顽力为20 A/m.19 μm厚的纳米晶薄膜的断裂应力达到785MPa,显微硬度达到605Hv.
关键词:
铁镍合金
,
薄膜
,
电沉积
,
纳米结构
,
性能
周晓宏
,
刘红军
,
刘鹏
功能材料
优化技术是一种以数学为基础,可用来求解各种工程问题最优解的应用技术.本文利用磁流变阻尼器动态特性数据,采用遗传算法进行阻尼器模型参数识别优化过程,最终将得到的磁流变阻尼器模型参数用于土木工程结构振动控制研究.已建立的磁流变阻尼器的动力特性将在不同的电场强度和变化的位移幅度下进行测试,可以得到在不同位移和速度下恢复力的滞回曲线,建立Bouc-Wen模型.把根据试验得到的滞回曲线和使用遗传算法对模型参数进行优化的结果进行比较可知,这种模型的参数可以以十分小的误差得到优化.
关键词:
遗传算法
,
阻尼器
,
参数识别
吕友军
,
董旭斌
,
张天宁
工程热物理学报
本文采用基于颗粒动力学的欧拉双流体模型,对比研究了曳力和湍流对超临界水流化床传热特性的影响,选取了Gidaspow、Syamlal-O'Brien和Wen-Yu三种曳力模型以及标准κ-ε、RNG κ-ε、Realizable κ-ε湍流模型三种高Re数湍流模型及低Re数κ-ε湍流模型.研究结果表明,在三种曳力模型中,Gidaspow曳力模型在超临界水流化床中更为适用;对于所采用的四种κ-ε湍流模型,利用三种高雷诺数湍流模型模拟所得床层与壁面间传热系数基本一致且大于采用低雷诺数模型模拟所得传热系数,而综合考虑,RNGκ-s湍流模型更适于超临水流化床传热特性的研究.
关键词:
超临界水流化床
,
曳力
,
湍流
,
传热
朱奎松
,
刘松利
,
芶淑云
,
王梁
钢铁钒钛
doi:10.7513/j.issn.1004-7638.2017.02.005
基于欧拉-双流体模型和流态化氯化临界流化速度经验公式,结合云南高钛渣物性参数,研究了其流态化氯化的初始流化速度下高钛渣流态化氯化特性、气泡运动对床层的扰动、气泡大小与分布板位置关系.研究结果表明:Grace方程能准确预测B类颗粒窄粒径的高钛渣流态化氯化气泡行为,Wen-Yu方程预测的初始流化速度下乳相和气泡出现时间延后;完全流化速度下,通过上升、合并长大、破裂过程,在分布板位置形成气泡;通过钛渣固体矢量图得出,整个床层以气泡为分界,气泡上升对上、下部颗粒的流动产生影响,导致床层不均匀.
关键词:
四氯化钛
,
高钛渣
,
氯化
,
流化床
,
数值模拟
,
流动特性
邓联文
,
周亮
,
李慧敏
,
黄生祥
,
丁丽
,
周克省
材料导报
利用ZnFeO4铁氧体材料居里温度对Zn含量敏感的特点,将其作为主成分,通过Cu、Ti离子掺杂技术调整居里温度并提高材料的温度稳定性.采用传统氧化物工艺制备CuTiZn尖晶石铁氧体材料;采用测量起始磁导率的温变曲线间接测量居里温度的方法,获得了CuTiZn磁热铁氧体材料的居里温度.结果表明,Zn含量增加将使居里温度快速下降;材料成分为Cu.0.45Zn0.55Ti0.03Fei.97O4时居里温度为44.9℃,起始磁导率达852.5,且居里温度点磁导率的变化率达50.3/℃,该组分的CuZnTi铁氧体具有良好的自控温灵敏度,可以用作温热疗法磁热材料.
关键词:
CuTiZn铁氧体
,
居里温度
,
磁热效应
,
温热疗法
马建勋
,
严密
,
赵传礼
,
肖洪博
,
文玉华
,
杨德仁
材料科学与工程学报
doi:10.3969/j.issn.1673-2812.2005.02.023
本文研究了Sm含量,凝固速度及Nb和Zr元素的添加对Sm-Fe合金微观组织及氮化后Sm2Fei7Nx合金磁性能的影响.研究结果表明:采用真空感应炉熔炼Sm-Fe合金,当Sm的补偿量大于10wt%时,合金铸锭组织中出现大量的富Sm相,这将导致氮化后磁体磁性能的恶化;提高铸锭的冷却速度及添加Nb和Zr等元素可以有效地细化铸锭中α-Fe相的晶粒,减少均匀化退火后α-Fe相的数量,提高磁性能.
关键词:
微观组织
,
Sm2Fei7Nx
,
磁性能
